next up previous contents
Next: error Up: eqwidth Previous: eqwidth

Examples:

The current model is assumed to be M1(A1+A2+A3+A4+M2(A5)), where the Mx models are multiplicative and the Ax models are additive.

XSPEC> eqwidth 3| Calculate the total flux of component A2 (the third component of the model) and find its peak energy (E). The continuum flux is found by the integral flux of A1+A3+A4, using the range of 0.95E to 1.05E to estimate the flux.
XSPEC> eqwidth range .1| As before, but now the continuum is estimated from its behavior over the range 0.9E to 1.1E.
XSPEC> eqwidth range 0| Now the continuum at the single energy range (E) will be used.
XSPEC> eqwidth range .05 2| Now the component A1 is used as the feature, and A2+A3+A4 are used for the continuum. The range has been reset to the original value.
XSPEC> eqwidth 1| Illegal, as M1 is not an additive component.
XSPEC> eqwidth 7| Illegal, as there is no other additive component with A5 in its group to be used as the continuum.



Keith Arnaud (kaa@genji.gsfc.nasa.gov)
Wed May 28 10:59:33 EDT 1997