next up previous contents
Next: response Up: XSPEC commands Previous: Examples:

renorm

Renormalize model, or change renorm conditions.

XSPEC> renorm [AUTO | NONE | PREFIT]

The renorm command will adjust the normalizations of the model by a single multiplication factor, which is chosen to minimize the fit statistic. Such a renorm will be performed explicitly whenever the command is used without a key-word, or during certain XSPEC commands, as determined by the following key-words:



Keith Arnaud (kaa@genji.gsfc.nasa.gov)
Wed May 28 10:59:33 EDT 1997