next up previous contents
Next: Examples: Up: XSPEC commands Previous: readline

recornrm

Adjusts the indicated data sets' correction norm by a single multiplicative factor that minimizes the fit statistic. This approach to fitting the correction norm is considered an INTERIM solution.

XSPEC> recornrm [<file range>...]

where <data set range> := <low data set> [-<high data set>] All the data sets specified by the one or more data set ranges on a single invocation of the command are multiplied by a single number, which is chosen to best reduce the fit statistic. If no ranges are given, then the last SINGLE range input is used. If you wish to fit a data set's correction norm individually, then refer only to that data set.

Note : The use of the recornrm command requires that a response and model be defined. It is perhaps best if a preliminary fit is performed. The user then should alternate between fit's and recornrm's until a stable solution is achieved. If the model is not a good fit, this process may not converge.





Keith Arnaud (kaa@genji.gsfc.nasa.gov)
Wed May 28 10:59:33 EDT 1997